Mounting your openVolver

Hang your openVolver on a lanyard from the middle mounting hole, or place two hooks in the corner holes to mount it without worrying about it flipping over.

Using your openVolver

To change the brightness, spin the thumbwheel at the bottom corner. The brightness will go up and down. For best battery life, keep brightness under 50%.

To change mode, click the button on the back of the PCB. The modes are:

1. Normal -- a mix of fadey and strobey, fast and slow, accelerating and deaccelerating
2. Fadey -- this is your mellow chillout blinky
3. Strobe Attack -- COVER YOUR BRAIN
4. Flashlight -- For those times in the portapotty where you know you best be careful.

Programming your openVolver

We now have cross-platform patterning software! Take the microSD card out of your openVolver, place it in the microSD to USB adapter, place that in a USB port in your computer, and then run the programming and librarian software found here!

That's it! Want to know more? Nerd Notes are here.